Give your layout a professionally finished look.
Two RJ12 6 pin LocoNet jacks in the back of the panel for hooking up LocoNet devices that use RailSync.
RJ12 6 pin Throttle jacks in the front of the panel for hooking up
throttles and other LocoNet devices that do not use RailSync.
additional RJ12 6 pin Throttle jack on the side of the panel for
hooking up LocoNet devices that do not use RailSync. For example, any
device that is not connected to other LocoNet devices beyond itself.
This extra throttle jack is great for connecting a DS54 or other local
Indicator LED that shows the power state of a local track section.
power jack that allows you to make the UP5 a battery saver terminal for
your throttles by plugging in a PS12 DC power supply.
Rear panel has two RJ12 jacks & two #6-32 right angle screw terminals for local track connections for power and diagnostics.
6 conductor telephone cable with RJ12 6 pin male connectors on each end
and it's easy to daisy chain your network around the layout without
worrying about hooking up a lot of wires. You can use your UP5 with
other Digitrax Universal Interconnect products such as the UP1, UP2,
UP3 and also with TelCo RJ12 6 pin type jacks. Click Here for UP5 Instructions. Click here for Super Empire Builder, see section 4.13 for more information about wiring LocoNet and using UP5s.
Built with Volusion